For Vertical Machining Center
DK｜Drum Type Tool Magazine
description：
DETAILED DESCRIPTION
• Powder dusts, fine chips or any contaminant may affect the accuracy of tool taper on a conventional tool pocket. However, dust adhering can be reduced by around 80%
when using tool pockets in this series.
• Standardized wiring and the use of connector-type sensor switch make it easy to maintain or replace motion sensors.
• Completely waterproof design with separate tool seats, easy to change to different tool specifications.
• Sanjet chooses cam that employs roller cam for tool change with maximum smoothness and stability.
place of origin：Taiwan
description
please swipe the page ← → to see content 。
|
Magazine Specification |
30# | 40# | 50# |
|---|---|---|---|
| Tool Specifications | BT(BBT)/CAT/DIN/ISO/HSK | ||
|
Tool loading capacity |
16/20/24/30/32 | 16/20/24/30/32 | 16/24 |
| Max. tool length | 250mm | 350mm | 400mm |
|
Max.tool full diameter full tool |
Ø70mm(16T) / Ø55mm(20T) / Ø60mm(24T) / Ø60mm(30T) / Ø55mm(32T) | Ø85mm(16T) / Ø95mm(20T) / Ø80mm(24T) / Ø75mm(30T) / Ø55mm(32T) |
Ø120mm |
| Max. tool weight | 3kg | 8kg | 16kg |
| Tool change time | 1sec/50HZ ; 0.84sec/60HZ | 1.6sec/50HZ ; 1.3sec/60HZ | 3.6sec/50HZ ; 3sec/60HZ |
| Tool selection | Shortest route tool selection | ||
| Tool change time | 0.7sec/50HZ ; 0.6sec/60HZ | 0.9sec/50HZ ; 0.7sec/60HZ | 1sec/50HZ ; 0.9sec/60HZ |
| Magazine motor | Standard motor | ||
| Drive | AC 3Ø 220V / 380V | ||
|
Air source pressure |
4-8kg/cm² | ||
.
